Watty
P1000645.JPG

Build Log

K149 - Shiznit #12

A new Shiznit made to replace one that I gave away to a friend.

Leading Edge

On previous Shiznits, I cut out a full opening in the leading edge around the upper and lower spreaders, but on this one I did it more like I do on other dual lines: just cutting out a small opening on either side of the fitting. I think this will result in a smoother, less snag-prone leading edge.

YoYo stoppers

I've built this with a different style of yoyo stoppers: The YoYo Stopper Prong. I've also adjusted the position of the yoyo stoppers. I think they were a bit low before, so I've moved them up toward the nose a bit

Lower Spreader fittings

I've recently started using 85A TPU instead of 95A TPU for the leading edge spreader fittings. I think this softer filament makes the fitting a bit more grabby and helps prevent the spreaders from popping out.