K138 - Tempest #7
One of four ultralight Tempests for my personal team set.
Upper spreader reinforcement
I seem to have placed the upper spreader reinforcement too high. This positioning was based on some written adjustments I made to my plans on a previous build. I guess I over compensated. Adjusting the plans slightly again.
Dye sublimation labeling
The dye sublimation for my labling came out a bit weak. I think my printer was due for cleaning the print heads. I've since cleaned the print heads and will see how it turns out for the next build.
Lower leading edge
I was 1 short for P2x spars for the lower leading edge. I subbed in a P200, which was slightly shorter, but it'll work for now until I get more P2x spars ordered. The lower leading edge is not glued or cut, so it'll be an easy swap later.
