Spreader Standoff Connector
Description
Connects the lower spreader to a standoff on a sport kite.
Includes parameterized holes for the spreader spar, and the standoff spar. Also includes a small hole that can be used to glue the fitting to the spreader.
Resources:
For the best experience, use the online Fusion 360 Project. The project includes parameters to adjust hole sizes and tolerances.
The Project is also available as a .f3d file here: Standoff Connector v40.f3d
Prepared STL files:
- 7mm x 5.5mm - A fitting with a 7mm internal diameter hole for the spreader, and a 5.5mm internal diameter hole for the standoff.
- 7mm x 4mm - A fitting with a 7mm internal diameter hole for the spreader, and a 4mm internal diameter hole for the standoff.
- 7mm x 3mm - A fitting with a 7mm internal diameter hole for the spreader, and a 3mm internal diameter hole for the standoff.
- 4mm x 2mm - A fitting with a 4mm internal diameter hole for the spreader, and a 2mm internal diameter hole for the standoff.
Printing Notes
I print these with Sainsmart 95A TPU, no supports, and 100% infill. Lay down on a flat side with the spreader hole facing up/down.